According to Bruce Bjorkman of MAK, his cookers use about 1/2 pound of pellets per hour when set on "Smoke" (about 175°F). At 450°F, the high temp, they burn about 2.3 pounds per hour. This is about the same average as I have experienced on a variety of pellet eaters. The burn rate will vary somewhat depending on the outside air temp, and how much cold meat is loaded in the grill, but cooking load should not have a major impact. Cooking pellets run about $1 per pound depending on the wood flavor, brand, if you get them on sale, and if you have to pay shipping. As a point of comparison, Kingsford briquets list for about $0.75 per pound, but they don't pack the same BTUs because there are fillers. I usually buy 40 pound bags of BBQr's Delight pellets from BigPoppaSmokers.com for $45 and shipping is free to IL. That's $1.13 per pound. That means that if I cook a slab of spareribs for six hours at 225°F I will probably burn about 4 pounds at about $4.50. If I put 8 slabs in there in rib holders, and allocate 1/2 slab per person, my cost for 16 people is about $0.28 each. If I grill a mess of chicken parts at about 325°F for about 1 hour, I will use about 1.5 pounds of pellets for a cost of $1.70.
If cost isn't an issue, check out the Elite Wood Fire. This 200+ pound behemoth from Memphis Grills costs more than some used cars, but it's fully loaded. Wifi-enabled, an extraordinary temperature range, and a cooking space large enough to be used by a small restaurant - the Elite has it all. The pellet hopper is built to match capacity, with enough fuel space to smoke for up to 62 hours straight.
Even seemingly perfect pellet grillers have trouble getting the cleanup part right even in light of how little ash is produced by pellets. You should search for pellet smokers and grills that efficiently keep the ash from building up on the heat deflector that’s located underneath the grates. The ash should remain on the ash cup and nowhere else. Meanwhile, major cleanup with soap and water is a hassle that requires an apron and gloves.
I did a lot looking around at pellet smokers before buying the ys 640. This thing is amazing! I have been cooking BBQ for about 15 years. I owned a Gator pit entertainer which is made in Houston Texas (stick burning pit) and I currently own a $25,000 Ole Hickory Pit EL-EDX which can cook 700 lbs of BBQ at once. I wanted something smaller to cook for family. The ys 640 turns out PERFECT Q every time! The amount of smoke is just right. Plenty of smoke flavor without over smoking which is very easy to do in my other pit. This is an EXCELLENT product which I strongly recommend.

I’ve been grilling and smoking for many years and throughout all those years I have burned through many expensive grills. Four years before I purchased the 640 I got on the pellet smoker wagon and started my research. Finally when my daughter was getting married she ask me to cook for the wedding and gave me the perfect excuse to finally get a smoker I wanted. So getting back to the research and after 3 months of comparing I settled on the YS640. I wanted a grill, at my age, to be able to pass down to one of my kids. It was big investment but like I’ve learned in life, you get what you pay for “most” of the time. I have had this grill now, September 2018, will be 4years now. I have no regrets and would do it again. I’ve had some minor corrosion issues and after an email was promptly sent the matching paint to clean it up. I spent the time to do it right and today, a month later, today my grill looks brand new. Honestly nothing like this can be left to take care of itself. Maintenance like anything else is required. But I know this will most likely be my last grill. Thank for a great product and great follow up service. Smoke Shack.....


I have found that using the upper shelf gets more airflow around the meat than the lower shelf. I asked the AmazingRibs.com science advisor Prof. Greg Blonder about the problem (he has a MAK 1 Star). He explained that smoke sticks to cool surfaces and wet surfaces, and the surface of meat warms and dries out after a few hours. When he wants more smoke flavor he uses a strong smoke wood like hickory or mesquite, he starts with cold meat, and then he keeps the meat moist by painting or misting it with apple juice or a mop like Lexington Dip or East Carolina Mop or Texas Mop Sauce. A awter pan can help because the water condenses on the cool meat and attracts smoke. Read his detailed research on the subject in my article on the Science of Wood and my article on Basting.

I am currently using a Bradley Smoker, which is basically an electric oven with a smoke generator that makes tons of smoke, using special Bradley Smoker pucks (of compressed saw dust). A tall cylinder hold a stack of pucks, and the smoke generator pops a new puck into the oven every 20 minutes or so (when the pucks are about 80% burned). Managing temps is not as difficult as a stick burner, but nothing like advertised with these pellet burners (like the Rec Tec).
Cleaning up after grilling is every cook’s dreaded part of the process, but this pellet grill simplifies that. Its warming rack comes with a patented ash-catcher system, the Ash Can Cleanout System, that allows for an easier cleanup of the unit. Additionally, it also features a grease drip disposal system that comes with a bucket. You won’t have to waste precious time cleaning up afterward!
Auger Making Weight Noises: It’s usually indicating a problem with the motor that’s responsible for rotating the augers. Under such circumstances, you would be left with no other choice than to replace the motor completely. Since the motors and augers are usually packaged together, this can get quite expensive. In such scenarios, it’s better to let it make noises and run for as long as it would serve you before going to replace it. However, once that problem occurs, you’d often find the auger not feeding the pellets at the expected rate and thus, the desired temperature might not be reached in some cases.
Cleaning/Maintenance: The grease catcher on this flat top is pretty decent. It is located on the bottom left hand side and all the oil/grease gets caught without anything dripping elsewhere. I usually wipe the grease catcher's orifice down with a paper towel to ensure it does not get clogged up over time. Other flat-top grills have either grease catchers that drip onto the leg of the grill or have them in the back of the flat top which is a little inconvenient getting to. As for cleaning after every use, I use a stainless steel scrapper/chopper to wipe the grill clean after I am done cooking. I scrape everything down into the grease catcher. For saucy foods or foods that might stick to the flat top, I use water when the grill is still hot to scrape it off and send it to the grease catcher. Afterwards, I put a little bit of oil onto the flat top and spread it all over using paper towels to maintain the seasoning before putting the cover on. Total clean-up time and re-seasoning takes roughly 3 minutes.
Maintenance is an issue. There are moving parts on these grills. Moving parts eventually break. There is an auger with a motor, and a fan with a motor. There are proprietary electronics systems on these babies. Augers clog. Motors burn out. Electronics have bugs or fail. Especially when exposed to rain, snow, hot, and cold. When they fail, will the manufacturer have a replacement part?
Traeger Scout Known Defective Product Jul 30, 2018 New grill has extreme temperature fluctuations. Set T 350 gets as HOT as 548 and as COOL as 275. Dealers are happily selling these while Traeger is aware per 1-800 call that they need to replace thousands of drip pans/heat exchangers on units that have been shipped because the ones in the units shipped allow heat to fluctuate widely. Traeger recommended NOT USING THIS BRAND NEW GRILL until I receive the replacement part which they will not receive until the last part of August and they will not commit to expedited shipping when they finally ship. WHY ARE THEY NOT ADVISING DEALERS THAT THE GRILL SHOULD BE PULLED OFF THE SHELF? How many have been sold since they discovered this malfunction? Don't they value their loyal customers and their reputation? Cooking Capacity Performance Design Portability Durability Quality Ease of Use Temperature Control Features Value Packaging Versatility You are receiving this email because of your shopping activity at www.traegergrills.com. Your privacy is very important to us; review our privacy policy here. © 2016 Traeger Grills 1215 E. Wilmington Ave Suite 200, Salt Lake City, UT 84106
Hey Brad, you’ve got 3 great grills there. Rec Tec has the edge on Pellet quantity. I like the build quality and support on the Grilla a bit better, especially with the extra insulation and updated comp wheel set up. Figure 10 min or so to get to top temps. Just remember to drop to around 300 F temp setting before going into the shut down cycle on any pellet grill if you’re cranking it up to the highest setting.
Cleaning and Maintenance: Keeping the grill clean is critical if you need to get the most out of the unit. Old debris can influence the viability of the unit thus normal cleaning is vital. In addition, while moving it around, take alert not to thump it since it accompanies little legs which can without much of a stretch tip over the unit when thumped.
Pellets are made from different woods, each of which imparts a distinctive flavor to the meat. Hickory, oak, maple, alder, apple, cherry, hazelnut, peach, and mesquite are among the flavors available. For more about pellets, read my article, The Science of Wood. There is a pretty good forum for people who have pellet cookers at PelletSmoking.com and of course our Pitmaster Club has a lively discussion on them with many active users.
With 440 square inches of cooking space, an auger-fed pellet delivery system, and a digital LED thermostat and controller, your cooking will be simple, whether it’s burgers, a whole turkey, or racks of ribs. The side shelf is a convenient place for cooking tools or plates while the bottom shelf can hold spare bags of pellets or jugs of sauces out of the way.
×